NP231 Transfer Case for Jeep 1989-1995 Wrangler & Cherokee

884,73 $

All units are quality inspected throughout the remanufacturing process to maintain our quality standard.
All cases are cleaned utilizing our state of the art hydro blasting and rinsing process. This process is what brings all cases back to the OEM finish.
100% replacement of seals, bearings, viscous couplers (when applicable) and other common wear components.
Units are shipped in high density plastic totes to help eliminate in-transit damage.

Description

Description
Application Notes: NV231; 23 Spline 0.75 Inch Exposed Length On Input Shaft, Bolt On Front Output Yoke, 27 Spline Slip Yoke Style Rear Output Shaft, 1.75 Inch Diameter Speedo hole, 2 Pin Shift Indicator Switch Above Shift Lever, 2 Piece Tail Housing, Tag Numbers: 52093497, 52097522, 52097695, 52097890, 52098362, 52098487, 52099695, 53005382, 53006096, 53008212, Hollander Numbers: 412-210, 412-309, 412-326, 412-328A, 412-328B, Other Numbers: UMT207-1.
Remanufacturing Process
Every transfer case we sell is fully remanufactured to meet or exceed OEM specifications. Our remanufacturing process:

Deep Clean – To start the remanufacturing process, each transfer case is fully disassembled and cleaned
Inspection – Each transfer case is carefully inspected for cracks, excessive wear, shaft warp, and chain stretch
New Components – All seals, bearings, joints and rings are replaced as well as electrical components (solenoids and control units)
Validation – After reassembly, each individual transfer case is spin tested as part of a detailed checklist validation process

Because of our rigorous remanufacturing process, we can offer the industry’s best warranty on remanufactured transfer cases. Each transfer case comes with up to 7 years and 1 million miles of warranty, which can be upgraded to include Pure Care™ no-fault protection. No other transfer case manufacturer comes close.